NEC MultiSync LCD1510V Bedienerhandbuch Seite 28

Installation E - 13
Shipping Screws
Loosen the two shipping screws (Figure SS.1). (The screws will not
come out. Turn them until they are loosened completely.) If the screws
are loosened correctly only the screen will rise up when lifting the
cabinet. (Refer to figure RL.1).
If the unit needs to be repackaged for shipping, make sure monitor is in
lowest Landscape position, then retighten the shipping screws in order
to protect the internal parts.
Cable Management
To use the cable management feature, lift up then remove back cover
(Figure CM.1). Place all cables into the vertical groove, leaving 15cm
to 25cm of slack in the cables to allow the monitor to rotate between
Landscape and Portrait orientation (Figure CM.2). To replace back cover,
push in then slide down (Figure CM.3).
Raise and Lower Monitor Screen
The monitor may be raised or lowered in either Portrait or Landscape
mode. To raise screen, place hands on each side of the monitor and lift
to the desired height (Figure RL.1). To lower screen, place one hand
under bottom of screen, lift slightly (Figure RL.2) and simultaneously
push the button on the bottom back of the stand (Figure RL.3). Screen
will lower while button is pushed in.
Release button to lock screen in place.
CAUTION: Although the monitor has been designed not to lower
automatically when the button is pushed, ALWAYS support the bottom
of the screen with one hand.