Erweiterungskarte -Profibus; Frontansicht; Anschlusstechnik; Anschlussbild - Danaher Motion Servostar 300 Handbuch

Kollmorgen
6.1.3
Expansion card -PROFIBUS-
This section describes the PROFIBUS expansion card for the SERVOSTAR 300.
Information on the range of functions and the software protocol can be found in our
manual "Communication Profile PROFIBUS DP".
If you ordered the expansion card together with the servo amplifier, then the expansion
card is already fitted and screwed into the slot when the servo amplifier is delivered.
The PROFIBUS expansion card has two 9-pin SubD sockets wired in parallel.
The supply voltage for the expansion card is provided by the servo amplifier.
6.1.3.1
Front view
6.1.3.2
Connection technology
Cable selection, cable routing, shielding, bus connector, bus termination and transmis-
sion times are all described in the "Installation Guidelines for PROFIBUS-DP/FMS" from
PNO, the PROFIBUS User Organization.
6.1.3.3
Connection diagram
®
SERVOSTAR 300 Installation Manual
11/05
SERVOSTAR 300
Expansions and Accessories
75