Trouble Shooting; Error Messages And Their Reasons - Buchi UV Monitor C-630 Handbuch

Büchi UV Monitor C-630

Trouble shooting

Error messages and their reasons

Error message
Deuterium lamp Lamp defect
doesn't start
Halogen lamp installed
with lamp menu setting
Deuterium
ERROR Zero position can not be
zero position! found
Deuterium lamp installed
with lamp menu setting
Halogen
Intensity Light intensity to high,
overflow e.g. during exchanging
the flow cell
ERROR: moving The filter wheel is
filter wheel blocked for any reason
If only ERROR is displayed press any key to continue. If there occur
repeated problems starting the lamp or with calibrations please
contact our service department.
The message ERROR interrupts a running program of your UV
Monitor C-630 as long as you have not pressed any key or an external
start signal executes the program newly. The message signal
overflow do not cause a program interruption.
probable cause
15
solution
Exchange lamp
Change the setting in
lamp menu
To perform a calibra-
tion switch the instru-
ment OFF and ON
Change the setting in
lamp menu
Push any key after
proper installing the
flow cell
If this reason is not
obviously, contact
our service