Monitor/Viewfinder Settings; Switching Displays - Leica Q Anleitung

EN

MONITOR/VIEWFINDER SETTINGS

Switching between monitor and viewfinder
The displays are the same, regardless of whether they appear on
the monitor or viewfinder.
In the menu you can determine if displays are shown on the
monitor or viewfinder. You can also determine if the switch should
take place automatically. Additionally, you can also change the
sensitivity of the corresponding sensor in the eyepiece in order to
ensure that the switch happens reliably, which is especially helpful
for eyeglass wearers.
1. Select
Display Settings
2. then in the sub-menu, and
EVF-LCD
3. select the desired setting in the corresponding sub-menu
Monitor brightness rendering
The brightness of the monitor display can be changed for optimized
recognition and adjustment to different lighting conditions.
1. Select
Display Settings
2. then
LCD Brightness
3. select the desired setting in the corresponding sub-menu
162
in the menu,
in the menu,
, and

Switching displays

In addition to the indicators on the upper and lower edge of the
monitor image (see "The Displays", page 248) further information
or auxiliary indicators are also available in the picture and review
modes.
Selection of the desired indicators
For picture mode
1. Select
Photo Live View Setup
2. then , ,
Level Gauge Grid Clipping
sub-menu, and
3. turn the respective function on or off there
In review mode, the corresponding settings for
are configured similarly under the
Histogram
option.
Switching indicators
Press the set button
You scroll through the different options in an endless loop and
select them by pressing once or several times.
in the menu,
, or in the
Histogram
and
Clipping
Play Mode Setup