Automatic Bracketing - Leica Q Anleitung

EN

AUTOMATIC BRACKETING

High contrast subjects that have both very bright and very dark
areas can have very different effects, depending on the exposure.
The automatic bracketing function enables you to take a series of
three pictures with graduated exposure. You can then select the
best picture for further use.
Setting the function
This menu option can be opened in two ways, either directly with
the FN button (as long as it has been configured for this function,
see page 157) or using menu control.
With the button
FN
1. Press the button (multiple times)
FN
The three functions
Exposure Bracketing ,
arranged in an endless loop.
Using menu control
1. Select
Exposure Compensation
2. press the set button or press right on the direction pad
The next step is identical in both cases.
Select the desired graduation on the corresponding scale
Details on how to proceed can be found on page 158. When the
menu option is opened using the
disappear again after 4s, further adjustments can only be made
within this time.
• The set graduations are displayed in red on the scale.
188
,
Exposure Compensation
, and
Flash Exp. Compensation
in the menu and
FN button, the scale will
While your setting will become active immediately when made by
opening the menu option with the
needed when opening it using menu control.
Press the set button
• Appears in the normal monitor image to the left of the light
meter.
Notes:
• Depending on the exposure mode, the graduations are produced
by changing the shutter speed (
• The sequence of the pictures is: correct exposure/underexposu-
re/overexposure.
• Depending on the available shutter speed/aperture combinati-
on, the working range of the automatic bracketing function may
be limited.
are
• A set bracketing setting remains active until it is reset to
even after any number of pictures and even after turning off the
camera.
button, extra confirmation is
FN
P / A / M ) or the aperture ( S ).
, i.e.
±0