Picture Default Settings; File Format; Jpeg Resolution - Leica Q Anleitung

PICTURE DEFAULT SETTINGS

EN

FILE FORMAT

Images can be recorded in
raw data format).
Setting the function
This menu option can be opened in two ways, either directly with
the button (as long as it has been configured for this function,
FN
see page 157) or using menu control. The settings that follow also
vary.
With the button
FN
Press the FN button (multiple times)
The two variations are set up in an endless loop.
• The set format appears in a window below in the middle of the
monitor image. It will disappear after 4s, further steps to change
settings can only be taken within this period of time.
Using menu control
1. Select
Photo File Format
2. select the desired setting in the corresponding sub-menu
Note:
The indicated remaining number of pictures or recording time are
an approximation, as the file size for compressed images can vary
considerably depending on the subject of the photograph.
166
and formats (picture
JPG DNG + JPG
in the menu,

JPEG RESOLUTION

If the JPG format is selected, pictures can be taken with four
different resolutions (numbers of pixels). This allows you to adjust
the setting precisely to the intended use or to the available
memory card capacity.
1. Select in the menu and
JPEG Resolution
2. select the desired setting in the corresponding sub-menu
Note:
Raw data (DNG format) is always stored at the maximum resolution
regardless of the settings for JPEG images.
The different resolutions of a resolution level relate to the selected
image section 28/35/50mm.