OEG KSW-E series Bedienungsanleitungen Seite 38

Para-
Function
meter
F1.19 MIN/MAX TEMPERATU-
RE LIMITATION
F1.20 SENSOR FOR MIN/MAX
TEMPERATURE LIMI-
TATION
Table with description of parameters
Para-
Function
meter
F2.1 OUTPUT PROGRAM-
MING
F2.2 DEPENDENCE TO
OTHER OUTPUTS
F2.3 DEPENDENT OUTPUT Selection of output on which depends operation of
F2.4 TIME PROGRAM FOR
OUTPUT
F2.5 THERMOSTATIC
OPERATION OF OUT-
PUT
F2.6 TYPE OF AUXILIARY
HEAT SOURCE
Service settings manual
Parameter description
Setting if controller should respect min. and max. tempe-
rature limitations of certain sensor by control of output.
This function is usefull by thermostatic operation of
output, where min. and max. temperature limitations of
particular sensor should also be respected.
Selection of sensor for the MIN/MAX limitation.
Parameter description
Selection of output for programming.
Define dependence of programmed output to other
controller's outputs.
&- selected relay has to be switched-on for program-
med output to be able to switch- on
&!- selected relay has to be switched-off for program-
med output to be able to switch- on
I- programmed output will switch-on always when
selected relay is switched-on
I!- programmed output will always switch- on when
the selected relay is switched-off
programmed output.
Selection of required time program for programmed
output.
Selection if programmed output operates as a thermo-
stat.
Selection of type of heating source.
:
40
Default
Setting range
value
0- NO
1- MIN OFF
2- MAX ON
3- MIN OFF & MAX ON
4- MIN ON
5- MAX OFF
6- MIN ON & MAX OFF
1- T1 2- T2
3- T3 4- T4
5- T5 6- T6
Default
Setting range
value
0- NO 1- R1
2- R2 3- R3
0- NO
1- &
2- &!
3- I
4- I!
1- R1
2- R2
3- R3
0- NO
1- P1
2- P2
3- P3
4- P4
5- SEL. PROG. TIMER
0- NO
1- YES
2- YES, INVERTED
3- YES, AUX. SOURCE
4- YES, CASC. SOUR-
CE
1- BURNER
2- EL. HEATER
3- HEAT PUMP
0
5
0
0
2
0
0
0