Service Manual; Controller Parameters And Auxiliary Tools; Basic Parameters - OEG KSW-E series Bedienungsanleitungen

CONTROLLER PARAMETERS AND AUXILIARY TOOLS

All additional settings and adjustments of controller performance are carried out by means
of parameters. In controller parameter settings menu there are three selectable groups:

Basic parameters

Service parameters
Heat metering parameters
Parameters for free programming available outputs.
You can only see those parameters which have an effect on the selected hy-
draulic scheme. Factory settings for parameters also depend on the selected
hydraulic scheme.
BASIC PARAMETERS
Basic parameters are divided into groups P1, P2 and P3. In group P1 there are setting for
differences and hysteresis for built-in thermostats, in group P2 there are settings for mini-
mum and maximum temperatures for individual sensors, and controller performance set-
tings in group P3.
When selecting the required parameter group in the menu, a new window opens:
Parameter mark
Diagram
of the setting
Parameter
description
(Help)
You modify the setting by pressing the button
The value of setting starts to flash, and you can edit it by pressing buttons
The setting is confirmed by pressing the button
buttons and to another parameter and repeat the procedure.
You exit the parameter settings by pressing button

SERVICE MANUAL

Current parameter value
27
Current parameter value
The last confirmed
setting value
Factory value
Setting range
.
. Now you can move by pressing
.
and .
Service settings manual