OEG KSW-E series Bedienungsanleitungen Seite 34

Table with description of parameters
Para-
Function
meter
W1.1 HEAT METERING
W1.2 MEDIUM
W1.3 GLYCOL MIXTURE
W1.4 HOT SENSOR
W1.5 COLD SENSOR
W1.6 FLOW METER
W1.7 IMPULSE RATE OF
FLOW METER
FLOW IN FIRST COL-
W1.8
LECTOR FIELD
FLOW IN SECOND
W1.9
COLLECTOR FIELD
W1.10 FLOW IN FIRST AND
SECOND COLLECTOR
FIELD
MIN. SOLAR POWER
W1.11
TO SWITCH-OFF AUX.
HEAT SOURCES
W1.12 OUTPUTS SWITCHED
OFF AT MIN. SOLAR
POWER
Service settings manual
Parameter description
With this setting we turn on the system which measures
acquired solar energy.
Select transfer medium in the solar system.
Set the glycol concentration.
By Tyfocor LS and G-LS this setting has no effect.
Select the sensor which is in collectors.
Select the sensor Tc which is on the return pipe into
collectors.
With settings you define whether there is a built-in flow
meter.
You insert characteristic data of flow meter - amount od
volume per impulse.
If you do not use the flow meter, read out and set flow
from the mechanic flow meter in first collector field when
the pump is running at 100 %.
If you do not use the flow meter, read out and set flow
from the mechanic flow meter in second collector field
when the pump is running at 100 %.
If you do not use the flow meter, read out and set flow
from the mechanic flow meter for both collector fields
when both pumps are running at 100 %.
This setting is used only by schems where both collector
fields can operate simultaneously.
Setting of solar collector power output, by which the
auxiliary heat sources should switch-off.
REMARK: This function is possible only if energy measu-
rement is activated and at least one auxiliary heat source
is selected.
Selection of auxiliary heat sources which should switch-
off if solar system exceeds setted power output.
:
36
Default
Setting range
value
0- NO
1- YES
0- WATER
1- PROPYLENGLYCOL
2- ETHYLENGLYCOL
3- TYFOCOR
4- TYFOCOR LS, G-LS
5- THESOL
10 ÷ 100 %
1- T1 (T3) 2- T2
3- T3 4- T4
5- T5 6- T6
1- T1 2- T2
3- T3 4- T4
5- T5 6- T6
0- NO
1- YES
0,5 ÷ 25 l/imp
1 ÷ 100 l/min
1 ÷ 100 l/min
2 ÷ 100 l/min
1 ÷ 20 kW
0- NONE
1- R1
2- R3
3- R1, R3
0
0
40
1
5
0
1
6
6
12
10
0