Adjusting The Settings For The [Ctl] (Control) Pedal; Adjusting The Functions Of The Pedals; Specifying How Pedals Behave When Pressed - Boss ME-80 Bedienungsanleitung

Convenient Functions
Adjusting the Settings for the [CTL]
(Control) Pedal
In Memory Mode of the ME-80, using the [CTL] pedal lets you
turn multiple effects on and off simultaneously, or switch the
setting value of a specified effect setting knob to a particular value
immediately (one knob at a time) . You can save the setting of the
[CTL] pedal to each patch .

Adjusting the Functions of the Pedals

1.
Press the [MEMORY/MANUAL] pedal to switch to Memory
Mode (p . 12) .
2.
Press the [CTL] button to switch to CTL Setting Mode .
Turning multiple effects on and off
3.
Select the effects you want to turn on and off by pressing
the corresponding pedals .
To cancel a selection, press that pedal once again .
The pedal indicators of the effects that want to turn and off blinks .
Setting the value for a particular knob
3.
Adjust the knob to the desired value .
To discard the knob settings, make an effect on/off setting .
* You can't specify the setting of each effect's TYPE knob .
MEMO
You can check the effect specified with the [MEMORY/MANUAL]
pedal before carrying out patch-write procedure .
4.
Save the setting by following "Saving Tones (Patch Write)"
(p . 12) procedure .
16
Specifying How Pedals Behave When
Pressed
The effect specified with Step 3 can either be switched with each
press of the pedal (TOGGLE), or only be turned on while the pedal is
pressed (MOMENTARY) .
The original factory settings are TOGGLE when the effect's on/off is
assigned and MOMENTARY when the value of the knob is assigned .
1.
When in Memory Mode, press the [CTL] button twice .
The unit switches to the setting mode for TOGGLE/MOMENTARY .
2.
Use the [BANK ] and [BANK
setting .
Display Settings
to
TOGGLE
mo
MOMENTARY
3.
Press the [CTL] button again .
* To cancel the setting, press the [EXIT] button .
4.
Save the settings as described in "Saving Tones (Patch
Write)" (p . 12) .
MEMO
The lit or unlit state of the [CTL] pedal indicator is linked to the
state of the indicator of the highest-priority effect of those you
turn on/off, according to the internal priority order .
The priority order is as follows .
COMP/FX1 > OD/DS > MOD > DELAY > PREAMP > EQ/FX2 >
REVERB > PEDAL FX
CTL Setting Mode indication
• If the effect's on/off is assigned and you are in CTL Setting Mode, "
be shown on the display and the pedal indicator of the effect that on/off is
assigned to will blink .
The effect pedal that on/off is
assigned to blinks .
• If the value of the specific knob is assigned, the indicator of the
corresponding effect will blink . Then "
the value is assigned to will be shown on the display .
The indicator of the effect that the
value of the knob is assigned to
blinks .
1- 2- 3- 4- 5-
1- 2- 3- 1- 3- 1-
2-
] pedals to choose the
Explanation
The effect switches with each press of the
pedal (factory setting when the effect's on/
off is assigned) .
The effect turns on only while the pedal is
pressed (factory setting when the value of
the knob is assigned) .
Ct
" will
Display
Ct
" and the number of the knob that
Display (changes alternately)
1- 2- 3- 4-
Knob number
2- 3- 1- 2- 3-