Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SETUP – POINT TO POINT
It is not necessary to run the signal through a network switch. To use as an HDMI extender:
1.
CONNECT TX TO RX Use a CAT6 cable to link a Tx directly to an Rx. The CAT6 cable must
be wired using normal IEEE-568B standard. It can be UTP or STP. Maximum length: 120
metres (394ft).
2.
SET "TX CONNECTED" CHANNEL ON RX to match the channel on the Tx.
TC-MATRIX_manual_en.doc
8
Werbung
Inhaltsverzeichnis
