Checking And Replacing The Battery; Advice - Num'axes CANIBEEP PRO Gerbrauchsanleitung

Checking and replacing the battery


The battery condition is checked in 3 distinct occasions:
– when you insert the battery
– when you turn the collar On
– when you turn the collar Off
During these 3 operations, if there are 6 close low pitch beep sounds, (instead of 1 or 2 low pitch
beeps sounds), your battery is also weak.
Replace the old battery by a new one of the same type (see § Fitting the battery).
NUM'AXES advises to use the same type and same brand of batteries as those supplied in
your new purchased product.
Other brands of batteries may not operate, or may not be completely compatible with your product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
When changing the battery, there can remain some power in your CANIBEEP PRO collar.
In that case, the collar does not emit any low pitch beep sound, and the LED does not light when
inserting the new battery.
To make sure it operates properly and that the battery is well inserted, turn your collar On with
the magnetic key (see § Switching on the collar).

Advice


When you put CANIBEEP PRO collar around your dog's neck, direct the sound diffuser upward,
so that beep noises do no come too close to your dog's ears.
We advise you to program your CANIBEEP PRO collar before putting it on your dog's neck:
– modes 1 to 4 : operates only when the dog is pointing
– modes 5 to 8 : operates when the dog is moving and then pointing
If you wish to train several dogs at the same time, we recommend you to program each
CANIBEEP PRO collar with a distinct tone in order to recognize each dog (you can choose
between up to 4 different tones).
If you follow these instructions, you will see that it will not take long before your dog
understands.
GB - 26