Checking/Replacing Battery Of Easy Dog Soft Or Easy Dog Pulse Remote Control - Num'axes EASY DOG SOFT Gebrauchsanleitung

S button: progressive static stimulations
Press the S button to send a warning to your dog using static stimulations transmitted by the two contact
points located on the receiver collar.
5 levels of stimulation are available (level 1: weak stimulation – level 5: strong stimulation).
When you press the S button, the indicator lights located on the remote control will come on (from 1 to 5
depending on the stimulation level reached).
The stimulation level increases automatically depending on how long you press the S button.
When you release the S button, the stimulation level will decrease one level at a time.
If you press the S button for more than 8 seconds, the collar will automatically go into safety mode for a
few seconds before restarting itself normally.
Checking/replacing battery of EASY DOG SOFT or EASY DOG PULSE remote
control
To check the condition of the battery, observe the indicator lights located on the remote control.
If the 5 indicator lights fl ash quickly 3 times when you press a button, the battery is weak.
Be prepared to replace it.
Performance (radio range) of the remote control may deteriorate as battery becomes weak.
NUM'AXES advises to use the same type and same brand of batteries as those supplied in your new
purchased product. Other brands of batteries may not operate, or may not be compatible with your
product.
You can purchase the suitable batteries from NUM'AXES or from your distributor.
Replace the old battery with a new one as follows:
- On the back of the remote control, use a coin to remove
the battery cover.
- Remove the old battery.
- Insert the new battery (3-V lithium CR 2032) making
sure the "+" noted on the battery is visible (ref. Diagram 7).
- Put the battery cover back in place and use a coin to close it.
- Check the remote control operates correctly.
Diagram 7
Replacing battery of
EASY DOG SOFT or EASY DOG PULSE
remote control
Gb - 27
WARNING
Make sure the polarity is correct
"+" of the battery must be visible