Setting The Movement Detection Sensitivity - Num'axes CANIBEEP PRO Gerbrauchsanleitung

Setting the movement detection sensitivity


When leaving the factory, the collar is set to an intermediate position (medium sensitivity). It
is up to you to adjust the sensitivity of your CANIBEEP PRO to your dog's behaviour and to the
results you want to obtain.
To change the movement detection sensitivity, you need to remove the lid of the collar in order
to get access to the sensitivity adjustment screw located inside the collar (see diagram 5).
2 examples:
a) After pointing, you want to always hear CANIBEEP PRO while your dog is sliding towards
the prey: with the supplied screwdriver, turn the sensitive screw counter-clockwise to the
minimum (minimum sensitivity). Collar is still beeping while the dog is moving.
b) You want to hear CANIBEEP PRO only when your dog is perfectly still: the collar stops beeping
at the slightest movement of the dog: with the supplied screwdriver turn the sensitive screw
clockwise to the maximum (maximum sensitivity).
CAUTION: The adjustment system has a stop for the minimum sensitivity and a stop for the
maximum sensitivity (maximum ¾ turn). Use the supplied screwdriver, turn delicately and
without forcing!
Less sensitive
to movements
Adjustment screw
for detection
sensitivity
to movements
More sensitive
to movements
GB - 24
Diagram 5
STOP
STOP
Minimum sensitivity
Medium sensitivity
Maximum sensitivity