Set Up Bluetooth Connection With Pc/Notebook; Preparations; Connecting - VEGA VEGAPULS WL S 61 Betriebsanleitung

Abb. 28: Example of an app view - Setup sensor
adjustment
Enter the requested parameters and confirm via
the keyboard or the editing field. The settings
are then active in the sensor.
Close the app to terminate connection.
7 Set up Bluetooth connec-
tion with PC/notebook
7.1

Preparations

System requirements
Make sure that your PC/notebook meets the
following system requirements:
•
Operating system Windows
•
DTM Collection 07/2019 or higher
•
USB 2.0 interface
•
Integrated Bluetooth LE
Activate Bluetooth connection
Activate the Bluetooth connection via the VEGA
project assistant.
Note:
Older systems do not always have an
integrated Bluetooth LE. In these cases,
a Bluetooth USB adapter is required
Activate the Bluetooth USB adapter
via the VEGA project assistant (see
supplementary instructions "Bluetooth
USB adapter").
After activating the integrated Bluetooth or the
Bluetooth USB adapter, sensors with Bluetooth
are found and created in the project tree.
VEGAPULS WL S 61 • 4 ... 20 mA

7 Set up Bluetooth connection with PC/notebook

7.2

Connecting

Connecting ...
Select the requested sensor for the online para-
meter adjustment in the project tree.
Authenticate
The window "Authentication" is displayed. For
the first connection, the operating device and
the sensor must authenticate each other. After
successful authentication, the next connection
functions without authentication.
Enter PIN
For authentication, enter in the next menu win-
dow the 4-digit PIN.
You can find the PIN:
•
Next to the type label on the connection
cable
•
On the supplement to the documentation
Note:
If an incorrect sensor PIN is entered,
the PIN can only be entered again after
a delay time. This time gets longer after
each incorrect entry.
Connected
After connection, the sensor DTM appears.
If the connection is interrupted, e.g. due to a too
large distance between sensor and operating
device, this is displayed on the operating device.
The message disappears when the connection
is restored.
Change sensor PIN
It is recommended to change the default setting
of the sensor PIN to your own sensor PIN. To do
this, go to the menu "Additional adjustments",
menu item "PIN".
31