Maico PP 45 O Installations- Und Inbetriebnahmeanleitung Seite 40

UK | 3 Safety instructions and warnings
Risk of injury/damage to unit if the
slide-in module (PP 45: 3 kg / PPB 30:
3.6 kg) falls down when being removed
(assembly/disassembly/cleaning/mainte-
nance).
 Sometimes the slide-in module is hard to
pull out/slide in.
Ensure that you are standing securely and
cannot lose your balance and that there is
no one under the unit.
 When removing and installing the slide-in
module, support it from below with a hand.
Risk of injury when working at
heights.
 Use appropriate climbing aids (ladders).
Stability should be ensured, if necessary have
the ladders steadied by a 2nd person.
 Ensure that you are standing securely and
cannot lose your balance and that there is no
one under the unit.
Risk of injury when handling housing
parts with sharp edges, e.g. stainless
steel external covers
Wear protective gloves.
Risk during transport from heavy or
falling loads.
 Observe applicable safety and accident
prevention requirements.
 Do not stand under a suspended load.
 Check unit for transport damage. Do not
commission a damaged unit.
Intended operation not ensured if
installed incorrectly. A ventilation unit
not installed correctly may result in operation
not as intended.
 Only install ventilation unit in accordance
with the planning specifications.
 In particular, note the information on insula-
tion and sound deadening.
40
Risk of injury and health risk when
using accessories which have not
been approved. The ventilation unit is tested
and approved with original accessories (e.g.
air filters).
 The unit may only be operated with original
components.
 Modifications and alterations to units are
not permitted and release the manufacturer
from any guarantee obligations and liability.
Damage to unit in the event of mois-
ture ingress. The ventilation unit has
PP 45 degree of protection. IP 00 / PPB 30:
IP X4.
 Do not install ventilation units and controls
outdoors.
 Protect ventilation unit from moisture and
wetness.
Risk of injury from damaged ventila-
tion units.
 Switch the ventilation units off immediately
if you discover damage or faults that could
endanger persons or property.
 Prevent the unit from being switched back
on until it has been fully repaired.
Danger of electric shock.
 Before removing the internal cover,
shut down all supply circuits (deactivate the
mains fuse) and secure so they cannot be
switched back on. Attach a warning sign in
a clearly visible place.
Danger if the relevant regulations for
electrical installations are not observed.
 Be sure to observe the relevant regulations
for electrical installation; e.g. DIN EN 50110-1.
In Germany, particularly observe VDE 0100,
with the corresponding sections.
 A mains isolation device with contact
openings of at least 3 mm at each pole is
mandatory.
 Only connect units to a permanently wired
electrical installation.
 The units may only be operated using the
voltage and frequency shown on the rating
plate.
230 V AC: RLS 45 O/K, PP 45/PPB 30 RC
12 V DC: PPB 30 O/K and PP 45 O/K