Network - Pioneer VSX-LX503 Bedienungsanleitung

Network

• When LAN is configured with a DHCP, set "DHCP" to "Enable" to configure the
setting automatically. ("Enable" is set by default.) To assign fixed IP addresses
to each components, you must set "DHCP" to "Disable" and assign an address
to this unit in "IP Address" as well as set information related to your LAN, such
as Subnet Mask and Gateway.
Setting Item Default Value Setting Details
Wi-Fi Off(Wired) Connect the unit to network via wireless LAN
router.
"On": Wireless LAN connection
"Off (Wired)": Wired LAN connection
• When switching between "On" and "Off(Wired)",
Wi-Fi Setup - You can configure wireless LAN settings by
pressing ENTER when "Start" is displayed.
Wi-Fi Status - The information of the connected access point will
be displayed.
"SSID": SSID of the connected access point.
"Signal": Signal strength of the connected access
point.
"Status": Status of the connected access point.
MAC Address - This is the MAC address of this unit.
This value is specific to the component and cannot
be changed.
DHCP Enable "Enable": Auto configuration by DHCP
"Disable": Manual configuration without DHCP
• If selecting "Disable", you must set "IP Address",
IP Address 0.0.0.0 Displays/Sets the IP address.
Subnet Mask 0.0.0.0 Displays/Sets the subnet mask.
Gateway 0.0.0.0 Displays/Sets the gateway.
DNS Server 0.0.0.0 Displays/Sets the primary DNS server.
Contents
stop the Network service. Also, when group
playback is in process, cancel the group
playback once, and then switch the setting.
"Subnet Mask", "Gateway", and "DNS Server"
manually.
Connections
≫
Setting Item Default Value
Proxy URL -
Proxy Port 8080
Friendly Name Pioneer VSX-
LX503 XXXXXX
144
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Displays/Sets the proxy server URL.
Displays/Sets the proxy server port number when
you enter "Proxy URL".
Change the device name for this unit which is
shown on other devices connected to the network
to an easily recognized name.
1. Press ENTER to display the Edit screen.
2. Select a character or symbol with the cursors
and press ENTER.
Repeat it to input 31 or less characters.
"A/a": Switches between upper and lower cases.
(Pressing MODE on the remote controller also
toggles between upper and lower cases.)
"←" "→": Moves the cursor to the arrow
direction.
" ": Removes a character on the left of the
cursor.
" ": Enters a space.
• Pressing CLEAR on the remote controller will
remove all the input characters.
3. After inputting, select "OK" with the cursors and
press ENTER.
The input name will be saved.
≫