Playing Back - Pioneer VSX-LX503 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für VSX-LX503:

Playing Back

Set the remote controller to the ZONE control mode (ZONE 2/ZONE 3)

100), and then perform the following operations.

1. Point the remote controller at the unit, and press .

• "Z2" or "Z3" on the display of the main unit lights up.

• ZONE 3 cannot be turned ON unless "Speaker" - "Configuration" - "Zone

Speaker" in the System Setup menu (

2. Press the input selector of the input source you want to play in the separate

room. When operating on the main unit, press the ZONE CONTROL button

repeatedly to select "Z2" or "Z3", and select the input to playback in other

room with the input selector dial within 8 seconds.

3. If the unit is connected to the pre-main amplifier in the separate room,

adjust the volume on the pre-main amplifier. If the unit is connected to the

power amplifier or ZONE speaker in the separate room, adjust the volume

on the remote controller. When operating on the main unit, press the ZONE

CONTROL button repeatedly to select "Z2" or "Z3", and adjust with the

MASTER VOLUME dial within 8 seconds.

• When adjusting the volume of the power amplifier placed in the separate

room by using this unit, set "Multi Zone" - "Zone 2" (or "Zone 3") - "Output

p135) to "Variable" on the System Setup menu.

• Information of a connected device can be displayed on the TV in the

separate room. Set the remote controller to the ZONE control mode (ZONE

2), and then press

• If you turn the unit to standby during multi-zone playback, the Z2 or Z3

indicator is dimmed, and the playback mode is switched to playback in a

separate room only. Setting ZONE 2/ZONE 3 to on while the unit is in standby

also switches the playback mode to playback in a separate room only.

• For ZONE 2 output, audio from externally connected AV components can

be output only when it is an analog or 2ch PCM audio signal. When the AV

component is connected to this unit with an HDMI cable, digital coaxial cable

or digital optical cable, change the audio output of the AV component to the

Front Panel≫ Rear Panel≫ Remote≫

p123) is not set to "Zone 2/Zone 3".