Connecting A Pre-Main Amplifier (Zone 3) - Pioneer VSX-LX503 Bedienungsanleitung

Connecting a Pre-main Amplifier (ZONE 3)

a
BD/DVD
a Analog audio cable
Contents Connections
≫
You can enjoy 2-ch audio in the separate room (ZONE 3) while performing
playback in the main room (where this unit is located). Use an analog cable to
connect the ZONE 3 PRE/LINE OUT jack of this unit and the LINE IN jack of the
pre-main amplifier or power amplifier in the separate room. The same source
can be played back in the main room and ZONE 3 simultaneously. Also, different
sources can be played back in both rooms.
• The ZONE 3 PRE/LINE OUT terminal can output only when "Speaker" -
"Configuration" in the System Setup menu (
following.
– When "Speaker Channels" is set to "2.1 ch", "3.1 ch", "4.1 ch", or "5.1 ch"
– When "Speaker Channels" is set to "5.1 ch" or "5.1.2 ch", and "Zone
Speaker" is set to "Zone 2/Zone 3"
– When "Speaker Channels" is set to "2.1.2 ch", "3.1.2 ch", "4.1.2 ch", or
"5.1.2 ch", and "Bi-Amp" and "Zone Speaker" is set to "No"
• To output audio from an externally connected AV component to ZONE 3, use
an analog audio cable for connection. Note that ZONE 3 output is not possible
with the connection using a HDMI cable, digital coaxial cable, or digital optical
cable.
a
LINE
IN
Premain Amp.
68
Playback
≫
p122) is set to one of the
Front Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫