Pioneer VSX-LX503 Bedienungsanleitung Seite 141

Setting Item Default Value Setting Details
Height 2 Left 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with
• "63 Hz" can only be selected when this speaker
• Depending on the use of the ZONE speakers, it
• If an item cannot be selected even though
Height 2 Right 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with
• "63 Hz" can only be selected when this speaker
• Depending on the use of the ZONE speakers, it
• If an item cannot be selected even though
Contents
/ , adjust
/ .
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
may not be possible to select this setting.
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
/ , adjust
/ .
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
may not be possible to select this setting.
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
Connections
≫
Setting Item Default Value
Surround Right 0.0 dB
Surr Back Right 0.0 dB
141
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with / .
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with / .
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
≫
/ , adjust
/ , adjust