Pioneer VSX-LX503 Bedienungsanleitung Seite 102

• When video and audio via HDMI input are output to ZONE 2, set "Input/Output
Assign" - "TV Out / OSD" - "Zone 2 HDMI" (
Setup menu.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD and Dolby TrueHD audio signals cannot be output to ZONE 2/ZONE 3
when selected with the "NET" or "USB" input selector.
• If ZONE 2/ZONE 3 is on, power consumption during standby will increase.
To set the function to off: Press
control mode. When operating on the main unit, press the ZONE 2 ON/OFF or
ZONE 3 ON/OFF button.
MULTI-ZONE MUSIC: If you press MULTI-ZONE MUSIC while playback is being
performed in the main room, the MULTI-ZONE MUSIC is turned on, "Z2" and "Z3"
on the display light at the same time and the playback sources of all the rooms
are switched to the same source at once.
• The sources that can be played in ZONE 2 can be played in all rooms.
• This function cannot be used if headphones are connected or audio is output
from the speakers of the TV.
• Depending on the setting of "Speaker" - "Configuration" in the System Setup
menu ( p122), it may not be able to output to ZONE 3.
p118) to "Use" on the System
while the remote controller is in the ZONE
Contents Connections
≫
102
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫ ≫