Pioneer VSX-LX503 Bedienungsanleitung Seite 148

restored to the previous statuses.
„ MCACC
MCACC EQ: Enable or disable the equalizer function that corrects for distortion
caused by the acoustic environment of the room.
• It cannot be set if the listening mode is Pure Direct.
Manual EQ Select: From the Home screen, select "Preset 1" to "Preset 3" which
were set in "MCACC" - "Manual MCACC" - "EQ Adjust". The same sound field
setting is applied all ranges when set to "Off".
• It cannot be set if the listening mode is Pure Direct.
Standing Wave:
Setting this "On" will control the effect of the standing wave
generated by the sound wave reflected by wall or similar interfering with the
original sound wave.
Phase Control: Correct phase disturbance in the low range to enhance the bass.
This enables you to achieve powerful bass reproduction that is faithful to the
original sound.
• It cannot be set if the listening mode is Pure Direct.
Theater Filter: Adjust the soundtrack that was processed to enhance its high
pitch range, in order to make it suitable for home theater.
• It cannot be set if the listening mode is Direct or Pure Direct.
„ Other
Sound Delay:
If the video is behind the audio, you can delay the audio to offset
the gap. Different settings can be set for each input selector.
• It cannot be set if the listening mode is Pure Direct and the input signal is
analog.
Sound Retriever: Improve the quality of the compressed audio. Playback sound
of lossy compressed files such as MP3 will be improved. The setting can be
separately set to each input selector. The setting is effective in the signals of
48 kHz or less. The setting is not effective in the bitstream signals.
• It cannot be set if the listening mode is Direct or Pure Direct.
HDMI Out: Select the HDMI OUT jack to output video signals from "MAIN",
"SUB", and "MAIN+SUB".
Contents Connections
≫
DRC: Make small sounds easily heard. It is useful when you need to reduce the
volume while watching a movie late night. You can enjoy the effect only when
playing Dolby series and DTS series input signals.
• It cannot be set if the listening mode is Direct or Pure Direct.
• The setting cannot be used in the following cases.
– If "Loudness Management" is set to "Off" when playing Dolby Digital Plus or
Dolby TrueHD
– When the input signal is DTS:X and "Dialog Control" is other than 0 dB
Center Spread: Adjust the width of the sound field of the front channel when
playing in the Dolby Audio - DSur listening mode. To spread the width of the
sound field to the right and left, set to "On". To concentrate the sound in the
center, set to "Off".
• Depending on the speaker settings, "Off" is applied.
Dialog Control: You can increase the volume of dialog portion of the audio up to
6 dB by 1 dB step so that you can hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not be selected.
148
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫ ≫