Pioneer VSX-LX503 Bedienungsanleitung Seite 124

Setting Item Default Value Setting Details
Height 2 Small Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Front" is set to "Small", this is set to
• If an item cannot be selected even though
Surround Small Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Front" is set to "Small", this is set to
• If an item cannot be selected even though
Surround Back Small Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Surround" is set to "Small", this is set to
• If an item cannot be selected even though
Contents
"Small".
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
"Small".
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
"Small".
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Connections
≫
Setting Item Default Value
Crossover 80Hz
Double Bass Off
„ Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value
Front Left 10.0 ft/3.00 m
Center 10.0 ft/3.00 m
Front Right 10.0 ft/3.00 m
Height 1 Left 10.0 ft/3.00 m
Height 1 Right 10.0 ft/3.00 m
124
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
When there are speakers that have been set to
"Small", set the Hz under which you would like
other speakers to play bass, and also set Hz under
which you would like the LFE (low frequency effect)
to play the bass.
The value from "50Hz" to "200Hz" can be set.
This can be selected only when "Configuration"
- "Subwoofer" is set to "Yes" and "Front" is set to
"Large".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
• The setting will not automatically be configured
even if you performed Full Auto MCACC.
Setting Details
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
Specify the distance between each speaker and
the listening position.
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
Specify the distance between each speaker and
the listening position.
• Depending on the use of the ZONE speakers, it
may not be possible to select this setting.
≫