Pioneer VSX-LX503 Bedienungsanleitung Seite 123

Setting Item Default Value Setting Details
Zone Speaker No Set whether speakers are connected to Zone 2 or
Zone 3 speaker terminals.
"Zone 2": When speakers are connected to Zone 2
speaker terminals
"Zone 2/Zone 3": When connecting speaker to both
ZONE 2 speaker terminal and ZONE 3 speaker
terminals.
• This setting cannot be selected under any of
"No": When speakers are not connected to Zone 2
speaker terminals
Bi-Amp No Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
• This setting will be set to "No" in either of
Speaker 6ohms Set the impedance (Ω) of the connected speakers.
Impedance "4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6ohms": When the connected speakers all have
6 Ω or more impedance
• For impedance, check the indications on the
Contents
following conditions.
– When the surround back speakers are used
– When 2 sets of height speakers are used
following cases.
– When 2 sets of height speakers are used
– When surround back speakers and height
speakers are being used at the same time.
– When "Zone Speaker" is set to "Zone 2" or
"Zone 2/Zone 3"
back of the speakers or their instruction manual.
Connections
≫
„ Crossover
Change the settings of crossover frequencies.
Setting Item Default Value
Front Small
Center Small
Height 1 Small
123
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Large" and the low
pitched range of the other channels will be output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Set the low range capabilities for each channel by
setting either small or large.
"Small": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low
range capabilities
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
≫