Connecting A Pre-Main Amplifier (Zone 2) - Pioneer VSX-LX503 Bedienungsanleitung

Connecting a Pre-main Amplifier (ZONE 2)

Premain Amp.
a Analog audio cable
Contents
LINE
IN
Connections
≫
You can enjoy 2-ch audio in the separate room (ZONE 2) while performing
playback in the main room (where this unit is located). Connect the ZONE 2 PRE/
LINE OUT jacks of the unit and the LINE IN jacks of the pre-main amplifier or
power amplifier in a separate room with an analog audio cable. The same source
can be played back in the main room and ZONE 2 simultaneously. Also, different
sources can be played back in both rooms.
• To output audio from an externally connected AV component to ZONE 2,
connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not
equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or
analog audio cable. Also, the audio from externally connected AV components
can be output to ZONE 2 only when the audio is analog or 2ch PCM signal.
When the AV component is connected to this unit with an HDMI cable, digital
coaxial cable or digital optical cable, change the audio output of the AV
component to the PCM output.
67
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫ ≫