X84; Multi-Zone Function (For Compatible Models Only); X84; Remote Controller; X84; Display; X84; Others - Pioneer VSX-LX503 Bedienungsanleitung

„ Multi-zone function (for compatible models only)

❏ Cannot ZONE-output the audio of externally connected AV components
• To output audio from an externally connected AV component to ZONE 2, connect it to any of HDMI IN1 to IN3 jacks. If the AV component is not
equipped with an HDMI jack, use a digital coaxial cable, digital optical cable or analog audio cable. Also, the audio from externally connected AV
components can be output to ZONE 2 only when the audio is analog or 2ch PCM signal. When the AV component is connected to this unit with an
HDMI cable, digital coaxial cable or digital optical cable, change the audio output of the AV component to the PCM output.
• When video and audio via HDMI input are output to ZONE 2, set "Input/Output Assign" - "TV Out / OSD" - "Zone 2 HDMI" (
the System Setup menu.
• To output audio from an externally connected AV component to ZONE 3, use an analog audio cable for connection. Also, audio from externally
connected AV components can be output to ZONE 3 only when it is an analog audio signal.
❏ Others
• If the audio signal is from the NET or USB input selector, zone output is not possible for DSD and Dolby TrueHD audio signals.

„ Remote Controller

• Make sure that the batteries are inserted with the correct polarity.
• Insert new batteries. Do not mix different types of batteries, or old and new batteries.
• Make sure that the sensor of the main unit is not subjected to direct sunlight or inverter-type fluorescent lights. Relocate it if necessary.
• If the main unit is installed in a rack or cabinet with colored-glass doors, or if the doors are closed, the remote controller may not work normally.
• After operating the Multi-zone function (for compatible models only), the remote controller mode may be switched to the mode for operating the
ZONE output audio. Check "Multi-zone", and switch the remote controller mode to the mode for controlling the main room.

„ Display

❏ The display does not light up
• When the Dimmer function is working, the display may go dim or turn off (for compatible models only). Press the DIMMER button, and change the
brightness level of the display.

„ Others

❏ Strange noise can be heard from the unit
• If you have connected another device to the same outlet as this unit, strange noise may occur under the influence of the device. If the symptom is
remedied by removing the power plug of the other device from the outlet, use different outlets for this unit and the device.
Contents Connections
≫
167
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
( p67)
p118) to "Use" on
( p98)
( p7)
≫