List Of Error Prompts - TE AT-30 Originalbetriebsanleitung

Electric Crimping Machine AT-300
11.2

List of Error Prompts

If an error occurs, an error prompt appears on
the display, like for example in Fig. 11.1.
Below you will find a list of the error prompts
with the corresponding explanation:
Error Prompt
048111000x01
048111000x02
048111000x03
048111000x04
048111000x05
048111000x06
048111000x07
048111000x08
048111000x09
048111000x10
048111000x11
048111000x12
048111000x13
048111000x14
Explanation
Supply voltage is too high
Supply voltage is too low
Wrong battery or battery
wrongly inserted
Battery empty
Fuse 1 on control board has
tripped
Fuse 2 on control board has
tripped
Power frequency cannot be
determined
Error prompt not assigned
Motor control error no. 1
Motor control error no. 2
Breaking error (Blackout of the
electrical brakes)
Display problems (if the display
fails, this error prompt cannot be
displayed)
Memory error
Motor is missing or defect
Seite / Page 76 / 85
IS412-94328 Rev. B
048111000x04
Troubleshooting
Move the voltage selector at the
backside of the machine to the
right voltage.
Move the voltage selector at the
backside of the machine to the
right voltage.
Insert the battery correctly.
Insert new batteries.
Send the machine back to TE
Send the machine back to TE
Send the machine back to TE
Send the machine back to TE
Send the machine back to TE
Send the machine back to TE
Send the machine back to TE
Send the machine back to TE
Send the machine back to TE
Send the machine back to TE
Fig. 11.1