Mounting An Adapter On The Machine - TE AT-30 Originalbetriebsanleitung

Electric Crimping Machine AT-300
8

Mounting an Adapter on the Machine

DANGER
Due to the risk of hand or finger injury, never try to reach into the electric Crimping Machine
+
AT-300 before having assured that the machine is disconnected from the power supply by
pulling out the main plug.
CAUTION
Do not operate the electric Crimping Machine AT-300 before having read and understood
+
all operating instructions.
The operating instruction must be constantly within reach of the electric Crimping Machine
+
AT-300. Every machine operator must have read and understood this operating instruction.
The safety instructions, warnings and precautions contained in the individual chapters must
be strictly observed by all users and operators when working on or with the electric
Crimping Machine AT-300.
The electric Crimping Machine AT-300 may only be set up and operated in perfect technical
+
condition, observing all the safety regulations and considering any possible dangers.
The crimp machine is only allowed to be used with mounted TE approved adapter with tool
+
head or with die set.
Assure free access to the operating elements of the electric Crimping Machine AT-300,
+
especially the foot pedal and the release button. In the case of imminent danger
immediately press the release button. The release button must be within the direct reach
of the operator. It must not be covered.
When working with the electric Crimping Machine AT-300, do not wear loose clothing,
+
jewellery or long, loose hair that can get caught in the mechanism.
Work with caution.
+
In cases of a malfunction of the machine or adapter incl. tool head or die sets, production
+
must be stopped and the malfunction must be fixed before continuing work.
Only one person is allowed to work on or with the machine at a time.
+
Only trained personal are allowed to work on or with the electric Crimping Machine
+
AT-300.
Before mounting the adapter, please pay
+
attention that the ram of the machine is in
the lowest position. If the ram is in
another/wrong position, please follow the
instructions of chapter 7.1.
Switch off the electric Crimping Machine
+
AT-300.
Pull out the pins 1 of the holding device
+
until stop.
Install the adapter on the machine from
+
above (Fig. 8.1/8.2).
Lock pins 1 of the holding device again.
+
INFORMATION
The SDE, CSE 30 and the ERGOCRIMP
+
adapters are always closed. To be able to
insert the contact, the lever on the adapter
has to be pushed downwards (see
chapter 9).
Seite / Page 68 / 85
IS412-94328 Rev. B
1
Example:Mounting of the SDE
adapter
1
Example: Mounting of the HTV 10
adapter
Fig. 8.1
Fig. 8.2