Set The Lowest Ram Position - TE AT-30 Originalbetriebsanleitung

Electric Crimping Machine AT-300
7.2

Set the Lowest Ram Position

To be able to mount the adapter, the ram of the machine has to be in the lowest position.
Switch the machine on and turn the key
+
switch to key position II.
Pay attention to the fact that the machine
+
is set for the full working cycle
(Fig. 7.5).
If this is not the case, touch icon
step 10 the following icon appears
machine is now in the full working cycle.
Keep the foot pedal and simultaneously
+
one of the safety buttons on the right or
left side pressed until the full cycle is
finished. The ram is now in the lowest
position (Fig. 7.6).
. After
. The
Seite / Page 65 / 85
IS412-94328 Rev. B
Counter:
759.103
Fig. 7.5
Lowest ram
position
Fig. 7.6