Responsibilities; Designed Use; Predictable Misuse - TE AT-30 Originalbetriebsanleitung

Electric Crimping Machine AT-300
2.3

Responsibilities

The electric Crimping Machine AT-300 may only be operated by suitably trained and
authorized personnel. The user must clearly define and observe the responsibilities of the
personnel for operation, set-up, maintenance and service. It is particularly important to define
who is responsible for work on the pneumatic equipment. Such work should only be carried
out by specially trained staff.
Should the user make any changes to the machine without consulting the
manufacturers or the suppliers, the latter will not be liable for any damage that may
result.
The user of the electric Crimping Machine AT-300 is responsible for making sure that all
persons involved in any way, either in the installation or in maintenance of the machine, have
been thoroughly trained on the system using the this operating instruction.
The user is also responsible for the training of operators and the instruction must include the
following aspects:
Purpose of the machine
+
Hazard zones
+
Safety rules and regulations
+
Functionality of the various components of the machine
+
Proper operation of the machine
+
To assure full familiarization with the system, the training must be conducted in the native
language of the operators involved.
Staff qualifications required in conjunction with the use of the electric Crimping
Machine AT-300:
Installation
Set-up
Instruction
Operation
Maintenance
Service
The safety instructions, warnings and precautions contained in the individual chapters must
be strictly observed by all users and operators.
2.4

Designed Use

Realization of crimp connections up to a cable Ø of 6 mm²/10AWG (wire end ferrules up to
+
50 mm²/1AWG) depending on the terminal design.
The electric Crimping Machine AT-300 is designed for usage with TE approved adapters . The
adapter should only be used with the tool heads/dies specified by TE. It is only allowed to use
the electric Crimping Machine AT-300 together with the adapter, tool head and die set for the
preparation of crimp connections!
INFORMATION
The electric Crimping Machine AT-300 only complies with the CE guideline, when using the
adapters shown in chapter 7.1!
2.5

Predictable Misuse

Every application which is not mentioned in chapter 2.4 „Designed Use".
+
Technical personnel with language proficiency in either English or
German, in addition to the native language of the operator.
Through qualified personnel trained as indicated above.
Technical personnel with proficiency in English or German.
Seite / Page 50 / 85
IS412-94328 Rev. B