Battery Exchange; Key Switch Exchange - TE AT-30 Originalbetriebsanleitung

Electric Crimping Machine AT-300
10.2

Battery Exchange

The batteries
048111000x04
Procedure:
Disconnect power supply.
+
Turn the battery compartments 1 under
+
the electric Crimping Machine AT-300 to
open them.
Insert the batteries (2 x 2 x 1,5V Baby
+
Cells Type C) one after another with the
negative pole pointing to the top.
Close battery compartments 1 by turning
+
them.
INFORMATION
Dispose of the battery according to
+
environmental standards of your country.
10.3

Key Switch Exchange

ATTENTION
Position the electric Crimping Machine AT-300 on a flat surface and assure the stability of
+
the machine. Ensure that the table or bench is stable enough to support the machine in
normal use.
If the keys for the key switch get lost, the key switch 1 (Fig. 10.3) has to be exchanged.
Procedure:
Disconnect power supply.
+
Remove holding device for the adapter.
+
Remove the cover carefully and ensure
+
that no cables are damaged.
Disconnect the plugs from the display and
+
the safety buttons left and right as well as
from the control element of the release
button.
Remove the control element of the key
+
switch.
Exchange key switch.
+
Assemble the control element with the key
+
switch.
Connect the plugs to the display and the
+
safety buttons left and right as well as to
the control element of the release button.
Mount cover and holding device for the
+
adapter.
have to be exchanged
Seite / Page 73 / 85
if the following error
1
IS412-94328 Rev. B
prompt appears:
Fig. 10.1
Fig. 10.2
01
Fig. 10.3