Double Step Mode - TE AT-30 Originalbetriebsanleitung

Electric Crimping Machine AT-300
7.3

Double Step Mode

The electric Crimping Machine AT-300 is set
by the manufacturer for the full crimping cycle
. Alternatively it can be operated in
double step mode
mode, the contact is fixed in the first step and
crimped in the second step. However, the
double step mode does not make any sense
in combination with the SDE, CSE 30 or
ERGOCRIMP adapter, since these adapters
close automatically.
After having touched the
machine can be operated in two separate
steps:
first step (Fig. 7.8) for holding the inserted
+
contact,
second step (Fig. 7.9) for crimping and
+
moving back into the final position.
The ram position can be adjusted to the
respective contact material by touching the
icon . Adjustments of ram position 1 (min.)
to 10 (max.) are possible.
INFORMATION
After ram position 10 the machine returns into
the full crimping cycle mode.
Ram Position
Step 01
Step 02
Step 03
Step 04
Step 05
Step 06
Step 07
Step 08
Step 09
Step 10
. In the double step
icon, the
Stroke of the Ram
ca. 3 mm
ca. 4 mm
ca. 5 mm
ca. 6 mm
ca. 7 mm
ca. 8 mm
ca. 9 mm
ca. 10 mm
ca.11 mm
ca. 12 mm
(closed dies)
Seite / Page 66 / 85
IS412-94328 Rev. B
Counter:
759.103
Counter:
759.103
Step
05
Counter:
759.103
Step
05
max. position
(position 10)
min. position of the ram (position 0)
Fig. 7.7
Fig. 7.8
Fig. 7.9
of the ram
Fig. 7.10