Set-Up Menu Key Position I; Display Calibration; Manual Motor Movement; Service Button - TE AT-30 Originalbetriebsanleitung

Electric Crimping Machine AT-300
7.4

Set-up Menu Key Position I

The set-up menu is only allowed to be used by supervisors or authorized personnel. Settings
to remedy mechanical errors or dysfunctions can be made in this menu.
INFORMATION
Key position I is only allowed to be used by supervisors or authorized personnel!
+
Key position I:
Set- Up Mode. The safety function of safety
buttons is deactivated. The machine can be
operated by pressing the foot pedal (only for
supervisors or authorized personnel!).
The display shows the following symbol:
Touching the icon
menu (Fig. 7.12).
To quit the Set-Up Mode, touch icon
7.4.1

Display Calibration

If the icons react on another place on the
display, the display has to be calibrated.
Please proceed as follows:
Touch icon
+
Follow the instructions on the display.
+
7.4.2

Manual Motor Movement

To move the electric Crimping Machine
AT-300 in crawling speed forwards or
backwards, please proceed as follows:
Touch icon
+
forwards stepwise/slowly (Fig. 7.12).
Touch icon
+
backwards stepwise/slowly (Fig. 7.12).
When releasing the icon, the electric
Crimping Machine AT-300 stops in this
position.
7.4.3

Service Button

The service button
only accessible for
turer of the electric Crimping Machine AT-300
and protected by a PIN (Fig. 7.13). This menu
comprises settings, which are only destined
for the assembly and adjustment of the motor
control.
to enter the set-up
to calibrate the display.
to move the machine
to move the machine
(Fig. 7.12) is
Service
the manufac-
Seite / Page 67 / 85
.
Calibrate Touch
Motor forward
Motor backward
0 1
5 6
IS412-94328 Rev. B
Counter:
759.103
Fig. 7.11
Service
Fig. 7.12
Enter PIN:
2 3 4
7 8 9
Fig. 7.13