Maintenance - TE AT-30 Originalbetriebsanleitung

Electric Crimping Machine AT-300
Crimping Process in Double Step Mode
1. Insert the crimp contact in the die profile or locator. Please pay attention to the correct
profile assignment and to the correct positioning within the crimp profile!
2. Press the foot pedal and simultaneously one of the safety buttons on the right or left side
of the machine to start the crimp process. The ram stops at the position you set (see chapter
7.2) and holds the contact.
3. The display shows the following icon
4. Insert the wire/cable which is stripped acc. to the specifications and position it for crimping.
5. Press the foot pedal and simultaneously one of the safety buttons on the right or left side
of the machine to start the crimp process.
6. Keep the foot pedal and the safety button pressed until the crimp cycle is finished.
7. Remove crimped contact.
10

Maintenance

DANGER
Before starting maintenance, disassembly or repair work, the crimping machine must be
+
disconnected from power supply by pulling out the main plug. Secure the machine to
prevent unintentional restart.
Touching live parts can cause danger of electrocution with fatal consequences!
+
DANGER
Due to the risk of hand or finger injury, never try to reach into the electric Crimping Machine
+
AT-300 before having assured that the machine is disconnected from the power supply.
CAUTION
Observe the maintenance intervals strictly.
+
Maintenance work may be performed only by authorized and properly trained staff. The
+
housing and the covers in particular may only be removed by specially trained staff.
Do not operate the electric Crimping Machine AT-300 before having read and understood
+
all operating instructions.
The operating instruction must be constantly within reach of the electric Crimping Machine
+
AT-300. Every machine operator must have read and understood this operating instruction.
The safety instructions, warnings and precautions contained in the individual chapters must
be strictly observed by all users and operators when working on or with the electric
Crimping Machine AT-300.
The electric Crimping Machine AT-300 may only be set up and operated in perfect technical
+
condition, observing all the safety regulations and considering any possible dangers.
Assure free access to the operating elements of the machine, especially the foot pedal and
+
the release button (latching). In the case of imminent danger immediately press the release
button. The release button must be within the direct reach of the operator. It must not be
covered.
When working with the electric Crimping Machine AT-300, do not wear loose clothing,
+
jewellery or long, loose hair that can get caught in the mechanism.
Wear protective gloves and safety glasses during maintenance work. Please pay attention
+
to the safety instructions in the "safety data sheet" of the grease.
Work with caution.
+
In cases of a malfunction of the machine or adapter incl. tool head or die sets, production
+
must be stopped and the malfunction must be fixed before continuing work.
Only one person is allowed to work on or with the machine at a time.
+
Only trained personal are allowed to work on or with the electric Crimping Machine
+
AT-300.
:
.
Seite / Page 71 / 85
IS412-94328 Rev. B