TE AT-30 Originalbetriebsanleitung Seite 49

Electric Crimping Machine AT-300
The crimping machine AT-300 has no own light source. Assure appropriate illumination of
+
the working place. (EN 1837:1999 – chapter 4.2: "The general value of illumination has to
be 500 lx [...]").
Place the cables on the floor or out of the way so that they do not cause a trip hazard!
+
Cables must not be damaged.
+
Place the foot pedal on the floor. No other place is allowed. The foot pedal must be
+
movable, so that the operator has the possibility to change his position for ergonomic and
production needs.
Do not lay the foot pedal in aisles or walkways.
+
Assure free access to the operating elements of the machine, especially the foot pedal and
+
the release button (latching). In the case of imminent danger immediately press the release
button. The release button must be within the direct reach of the operator. It must not be
covered.
To ensure fatigue-proof use, the user has to take a working position where the machine is
+
at the right height and the foot pedal is accessible. The foot pedal has to be installed in a
stable position.
Before starting maintenance, disassembly or repair work, the crimping machine must be
+
disconnected from power supply by pulling the main switch. Secure the machine to prevent
unintentional restart. Touching live parts can cause danger of electrocution with fatal
consequences!
Maintenance work may be performed only by authorized and properly trained staff. The
+
housing and the covers in particular may only be removed by specially trained staff.
Due to the risk of hand or finger injury, never try to reach into the electric Crimping Machine
+
AT-300 before having assured that the machine is disconnected from the power supply.
The electric Crimping Machine AT-300 is only allowed to be operated with properly
+
mounted TE approved adapters, crimp heads and crimp die sets.
The electric Crimping Machine AT-300 may only be set up and operated in perfect technical
+
condition, observing all the safety regulations and considering any possible dangers.
In cases of a malfunction of the machine or adapter incl. tool head or die sets, production
+
must be stopped and the malfunction must be fixed before continuing work.
Before starting to handle/solve the problem, the machine has to be disconnected from
+
power supply by pulling out the main plug. Secure the machine to prevent unintentional
restart.
Maintenance work and problem handling may be performed only by authorized and
+
properly trained staff.
The electric Crimping Machine AT-300 is not operable, until the problem has been solved.
+
Work with caution.
+
Only one person is allowed to work on or with the machine at a time.
+
Only trained personal are allowed to work on or with the machine.
+
When working with the electric Crimping Machine AT-300, do not wear loose clothing,
+
jewelry or long, loose hair that can get caught in the mechanism.
Wear protective gloves and safety glasses during maintenance work. Please pay attention
+
to the safety instructions in the "safety data sheet" of the grease.
Observe the maintenance intervals strictly.
+
Dispose of the battery according to environmental standards of your country.
+
For the disposal of the electric Crimping Machine AT-300, send it back to TE.
+
Seite / Page 49 / 85
IS412-94328 Rev. B