Basic Functions; Antenna; Battery Pack; Charging - Team Electronic TeCom-LC VHF-COM Bedienungsanleitung

English
1
5
7
8
9
4
24

1 - antenna

2 - On/Off and volume
3 - rotary channel selector
4 - microphone
5 - speaker
6 - LED
7 - PTT key
8 - multi function key PF1
9 - multi function key PF2
10 - ear- / microphone connector
11 - battery pack Li-Ion, 1300 mAh
with battery clip
3
2
6
10
Antenna
Please note: by law, the antenna of the PMR version must be fixed. With all other
versions the annenta can be removed.
Mount the antenna onto the radio by turning the antenna threat clockwise onto the
antenna socket.

Battery Pack

To mount the battery pack onto the radio, place the battery pack flat-bottomed, with
the three contacts on top, onto the rear of the radio, the lower part standing over the
radio edge. Now, push the three guide noses, on the top of the battery pack, into the
counter part. The lock will snap-in.
To remove the battery pack, push the lock, located on the bottom of the battery pack,
down and, at the same time, push the battery out.
Belt Clip
For mounting the belt clip on the rear of the radio, please use only the screws that
are included in the scope of delivery.
Charging of the Battery Pack
Prior to the first usage, the battery pack (11) has to be charged completely. For char-
ging, use only the charger SLG-TeComLC that is included in the scope of delivery. A
full charging cycle takes about five hours. Remove the battery pack at the end of the
charging process of the base station. Overcharging will shorten the battery pack's
longevity.
Connect the power supply that is included in the scope of delivery with the charger
and the 220V power system. The LED will switch between red and green.
Place the radio with the mounted battery pack into the charger. Pay attention that the
battery pack is placed correctly. The guiding grooves at the sides of the battery pack
11
have to be placed into the couter parts of the base station.
During charging, the LED lights red. Once the charging process is completed, the
LED lights green.

On / Off

To power on the radio, turn the combined On/Off-Volume knob (2) clockwise over the
threshold. A short beep tone is emitted and, if voice annunciation is activated, you can
hear "power on", followed by the actual channel number.
To turn off the radio, turn the On/Off switch counterclockwise over the threshold.

BASIC FUNCTIONS

English
25