Herunterladen Inhalt Inhalt Diese Seite drucken

Basic Functions; Antenna; Battery Pack; Charging - Team Electronic TeCom IP-DA32 Bedienungsanleitung

Handfunkgerät
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

English

1 - antenna

2 - on/off and volume
3 - rotary channel selector
4 - microphone
5 - speaker
6 - LED
7 - orange twin-function key TK1
8 - PTT key
9 - twin-function key SK1 and SK2
10 - ear-/headphone connector
11 - battery pack Li-Ion, 1600 mAh
26
1
6
5
8
9
3
Antenna
With the dPMR-446 version, due to governmental regulati-
ons, the antenna is fixed, i.e. non-detachable.
7
2

Battery Pack

To attach the battery pack (11), place the battery pack onto the radio and press the
bottom part close to the radio case and close the lock.
4

Charging

Prior to first use, the battery pack has to be charged completely. A complete charging
cylce takes approximately three hours. During the charging process, the LED lights
red. Once charging is completed, the LED lights green.
Remove the battery pack out of the charger. Overcharging reduces the battery packs
longevity.

On / Off

To turn the radio on, turn the On / Off switch (2) clockwise beyond the barrier.
If the according functions are activated, the LED will light red until the boot-up is fi-
nished, which will be confirmed by a beep tone. Please note that with digital radios,
it takes approximately three seconds to finish the boot-up.
To turn off the radio, on, turn the On / Off switch (2) counterclockwise beyond the barrier.
10
Volume Control
To set a comfortable volume level after turning the radio on, select an analog channel,
and activate the monitor function by pressing the according multi-functional key SK1/2
(9) (which has to be programmed via software) while adjusting the volume level with
the combined On/Off-Volume key (2).
11

Channel Selection

For channel selection, use the 16-step rotary channel selector (3) switch. The channels
are selected in the programmed order of the selected channel group, i.e. channel group
1 (Area1) 1-16 and channel group 2 (Area2) 17-32.
To toogle between the 2 channel groups, the function Area Switch has to be programmed.

BASIC FUNCTIONS

English
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis