3.4 Installation Example
The sensor should be in-
stalled so that the sensor
fingers point toward the
center of the tank, this will
protect the sensors from
any debris that may fall
into the separator.
The sensor should be in-
stalled so that the base of
the pointed green arrow is
at the exact height of the
separator's water level du-
ring calm / clean conditions
(no fuel or oil in separator)
3. Installation and Assembly
No attachment of the drill holes
(mounting bracket Sonic Control)
in the region of the seal
The level "static water
level" is reached when
wastewater flows out of
the drain tube in the
sampling.
Distance between base
of pointed green arrow
and chamber bottom
(for dimensions see
table S.9
46