1)The separator contents should be emptied when the sludge layer is 50% full
2)The separator contents should be emptied when the oil / fuel layer is 80% full – not disposing at this stage would exceed the oil / fuel storage capacity of the separator
Note:
For more articles please contact the KESSEL customer service. After installation completely fill the separator with water, check height and
correct if necessary! Completely filled separator must perform the "manual mode" (2.1) SonicControl "0 cm" show. Should be no mechanical
correction possible change in "Parameters -> level adjustment"(3.1.7) to perform.
Adjustment of the SonicControl sensor can be handled with two different methods: By measuring with a ruler (separator must be empty in
The parameters are password protected - please contact the KESSEL customer service at +49 (0) 8456/27462.
order to use this method) or the sensor is adjusted using the colored marks. The separator must be filled with clean water in order to use this