Kessel SonicControl Anleitung Für Einbau, Bedienung Und Wartung Seite 47

Ill. shows an underground fuel separator size NS 6 to NS 15
inside
Order-Nr. 917822
3. Installation and Assembly
During the installation of the underground fuel separator, a DN 40 (OD 50mm) conduit pipe should
be laid two the separator dome that will contain the SonicControl sensor. In the dome area of the
separator tank (as seen in the above ill.) a 60mm hole should be drilled out of the tank using a
hole saw. The control unit and the separator should be located as close to each other as possible.
outside
The conduit pipe should be laid with no bends over 45 degree (maximum fitting bend should be
45 degrees). The conduit pipe should be installed with a constant slope toward the separator so
that any condense water will flow back into the separator and not toward the control unit or pond
in the conduit pipe. In the case that the conduit may need to be extended at a later date or the
sensor cable needs to be replaced, a string can by laid in the conduit pipe to aid running new ca-
bles. The SonicControl cable may be extended to a total length of 60 meters. The cable screw
must be tightly fastened before running the SonicControl cable back toward the control unit.
Finally secure tightly the black plastic conduit pipe cover. If a back up occurs inside the sepa-
rator the SonicControl sensor must be inspected and cleaned if necessary.
47
Ill. shows an underground fuel separator size NS 3 to NS 6