4.4 Installation / Cable Connections
The SonicControl cable may not be laid with
together with any other electrical systems /
circuits. Do not lay the cable with any other
cables in order to prevent electrical interfe-
rence which can cause the SonicControl to
malfunction. The sensor itself should not be
grounded.
The SonicControl cable is to be connected
to the control unit as stated in this manual.
Connect the cable to the connection jacks
located on the left side inside the control
unit near the partition wall.
4. Electrical Connections
IMPORTANT:
All cables entering the control unit should be se-
cured properly secured with a tie-wrap or cable
clip to prevent any danger to the unit or the ope-
rator in the case that a cable connection comes
loose. The sensor cable should be laid separately
from the control unit's power cable to prevent in-
terference.
49