8.3 Information menu
System info
Informations
Maintenance
Settings
8. Control Unit
8.3.1 Operating hours
Display of all system operating times.
8.3.2 Log book
Operating hours
Chronological display of incidents and faults (see also chapter 7 "Incidents and
faults / remedial measures")
Log book
All changes made to the settings are saved at this point.
8.3.3 Control unit type
Control unit type
Display of system time, grease separator type, language and software status.
8.3.4 Servicing date
Servicing date
Display of the next necessary and last performed servicing.
Current measured
Note: Data are only available if these have been stored in the "Settings" menu by
values
the servicing partner.
Parameters
8.3.5 Current measured values
Pressing the OK key carries out a measurement of the current
Measured data
grease layer thickness.
Disposal
8.3.6 Parameters
Display of all set control parameters of the system It is not possible to change the
parameters in this menu.
8.3.7 Measured data
Display of the last layer thickness and temperature stored (max. 400 values).
8.3.8 Disposal
Display of details of the last disposal carried out (if stored)
59