Machine Storage; Troubleshooting - WOODLINE WL 13 C/1000 EL Bedienungs- Und Wartungshandbuch

8.2) Replacing used oil:
Replace the oil after every 1000 hours' operation.
To replace the oil, unscrew the filling cap (A) and remove the oil suction filter
(B). Empty the tank completely and refill with the amount of oil shown in the
"Technical data" table, having replaced the filter with a new one. Close the
GB
filling cap.
Hydraulic oil is a pollutant, so follow the legal requirements
in force regarding the disposal of used oil.
Always use the oil type indicated by the Manufacturer or an equivalent
(see technical data).
8.3) Greasing:
Regularly grease all joints on the machine controls such as control arm
hinges, compensator supports, blade holder rod, and distributor control rod.

8.4) Machine storage:

When the machine is no longer required, stop the machine with the blade
holder rod fully retracted (cylinder closed see para. 6).
Carefully clean the machine of all working residues and grease all the control
joints.
Place the machine in a sheltered store, protected from the atmosphere and
from dust.
If the machine is not used for long periods of time, it is recommended to lower
the cylinder in order to make the machine smaller.
- Start the machine and press both handles to make the rod come out to the
height of the worktable.
- Release one handle and slide out the cylinder plugs.
- Release both handles and make the cylinder descend to the required height.
- Switch the machine off.

9) TROUBLESHOOTING

REF. PROBLEM
The wedge does not move when the
1
machine is first started.
The wedge does not move.
2
The wedge does not lock when a handle
3
is released.
When both handles are released, the
4
wedge does not return to its starting
position.
The wedge descends when only one
5
handle is activated.
A
CAUSE/REMEDY
- If you have a log splitter mod. EL380V, invert the
polarity of the electrical connections and if the
problem persists see the next point.
- Check that the hydraulic pipes are intact and make
sure that there are no oil leaks near the pump.
- Check that there is enough oil in the tank.
- Contact the technical assistance service.
- Contact the technical assistance service.
- Make sure the wedge stroke is correctly adjusted.
- Contact the technical assistance service.
- Contact the technical assistance service.
3.2) Hinweisschilder:
Die auf dem hydraulischen Holzspalter angebrachten Hinweisschilder lenken
die Aufmerksamkeit auf einige Aspekte der Benutzung der Maschine.
Im Folgenden werden die Piktogramme sowie deren Bedeutung
wiedergegeben.
B
BEZ.
1 Pflicht, das Handbuch vor der Benutzung der Maschine vollständig zu lesen
2
3
4
5 Verbot, Sicherheitsvorrichtung bei laufender Maschine zu entfernen
6
7 Verbot, in Bewegung befindliche Bauteile zu reparieren, zu ölen, einzustellen oder zu reinigen
8
9
VERSIONEN MIT KARDANWELLE
10
11
BEDEUTUNG
Gefahr der Quetschung der Hände
Gefahr der Quetschung der Füße
Gefahr durch das Vorhandensein der Kardanwelle
Gefahr durch tödliche Stromstöße
Pflicht, Personenschutzvorrichtungen zu tragen
Pflicht der Benutzung durch nur eine Person
Anweisungen zur Pumpe
Minimale Abdeckung der Schutzhaube
37
WL 13-16-20 C/1000
D