Zusatzvorrichtungen; Safety Devices; Markings And Identification - WOODLINE WL 13 C/1000 EL Bedienungs- Und Wartungshandbuch

Stop the machine with the blade holder rod fully retracted, which means closed (see "Machine storage").
Always check the stability of the machine.
Always check the stability of the machine and make sure that the fixing pins for the table (where
GB
included) are present.
Before starting the machine, make sure that there are no objects placed on the machine itself that
could cause danger or become caught in the machine, fall or slide and cause errors or dangerous
situations.
The machine conforms to the safety standards, and any tampering with or modification of the system will
invalidate all the necessary requirements for the safety standards and for the warranty.
The motor and electrical parts are protected to grade IP 54.
With electrically operating log splitters, use a portable residual current device (PRCD) if the electrical system
is not fitted with a residual current device (RCD) and maximum residual current of 0.03 A.
If an extension cable is used, make sure that it: - conforms to the laws in force - is in perfect condition
- has a suitable section to support the current absorbed by the machine.
Too small a cable may cause voltage fluctuations on the line, with a consequent loss of power
and/or overheating.
Only use the log splitter for splitting wood logs of the sizes indicated in the TECHNICAL DATA
table. Never try to obtain higher performance than is foreseen for the machine as this could create
hazards.
The machine must always be maintained in a clean orderly fashion, eliminating wood residues, oil, grease
and so on.
The operator must have full control over the machine without reserve and must be suitably trained in
the use of the machine.
The operator must fully understand the hazards deriving from the use of the machine.

2.1) Safety devices:

This machine is equipped with a safety system that must not under any circumstances be tampered with.
Check regularly that all safety devices are functioning correctly.
To remove all risks of crushing, the machine must be operated using both
hands.
The release of even one hand causes the blade holder rod to stop
immediately.
In case of power cut-out, the blade holder rod stops automatically, and
when the power is restored it moves back to the maximum height.
The machine is also equipped with an emergency stop (B) that, when
pushed upwards, activates a circuit that locks the wedge return and stops
any obstacle from being crushed between the frame head and the wedge
itself.
This lever can also be used as a safety device to stop the wedge at
any time in case of emergency.
3) MARKING AND
IDENTIFICATION
3.1) Marking:
The MARKING plate, which
s h o w s t h e m a i n
identification data, is
positioned on the machine
frame.
B
22
WL 13-16-20 C/1000

10) ZUSATZVORRICHTUNGEN

Lesen Sie vor der Montage von Zusatzvorrichtungen aufmerksam das gesamte Handbuch
sowie das Handbuch, das der Zusatzvorrichtung beiliegt.
VERBREITUNG-
SKEIL
KREUZKEIL-
STÜCK
KIT KORB MIT
HALTERUNG
VERBREITUNG-
SKEIL
KREUZKEIL-
STÜCK
KREUZKEIL-
STÜCK
TISCH
SEITENARME
KREUZKEIL-
STÜCK
KREUZKEIL-
STÜCK
HOLZHALTEB-
LECH
WL 13-16-20 C/1000
47
D