Add-On Modules; Technical Data - Danfoss Icon Installationsanleitung

Installation Guide

Add-on Modules

Technical data

12 | © Danfoss | FEC | 2019 .01
Danfoss Icon™ Master Controller 24 V
You can extend the functionalities of Danfoss
Icon™ Master Controller 24V with Add-on Modules .
Radio Module
By adding a Radio Module the Danfoss Icon™
Master Controller 24V is converted from a wired
to a wireless solution . The wireless solution
provides a higher degree of flexibility in placing
the thermostats . In a wireless system, each Master
Controller must have it's own Radio Module .
For more information, see the installation guide
supplied with the Radio Module .
Expansion Module
By installing an Expansion Module the Danfoss
Icon™ Master Controller 24V can be used with more
applications such as electronic mixing shunt control
or in cooling applications . Just install the Expansion
Module, choose the appropriate application
from a list and make the wiring according to the
description – then the configuration is made
automatically .
For more information, see the installation guide
supplied with the Expansion Module .
Common characteristics, all Danfoss Icon™-products
Temperature for the ball pressure test
Control polution degree
Software class
Rated impulse voltage
Operating time
Temperature range, storage and transportation
Dispossal instructions
Full data sheet available at www.danfoss.com
Radio Module & Repeater
Purpose of control
Ambient temperature range, continious use
Frequency
Transmission power
Encapsulation (IP Class)
Conformity declared acc . to following directives
Protection class
Supply voltage
App Module
Purpose of control
Ambient temperature range, continious use
Frequency
Encapsulation (IP Class)
Conformity declared acc . to following directives
Protection class
Supply voltage
App Module
By adding an App Module to Danfoss Icon™ Master
Controller 24V the system enables app support
for control via smart phones (supports IOS and
Android) . For more information, see the installation
guide supplied with the App Module .
Repeater
Add a repeater in
large buildings where
added wireless range
is needed . Set Master
Controller to INSTALL
mode to add a
repeater .
For more information,
see the installation
guide supplied with
the Repeater .
75 °C
Degree 2, normal household environment
Class A
4 kV
Permanently connected
-20 °C to + 65 °C
The product must be disposed as electronic waste .
Transmitting and receiving device
0 °C to + 40 °C
869 MHz
<2,5 mW
IP 20
RED, RoHS, WEEE
Radio: Class III Construction Repeater: Class II Construction
Radio: 5 VDC Repeater: 230 VAC 50/60 Hz
Wi-Fi transmitting and receiving device, incl . Bluetooth
0 °C to + 40 °C
2,4 GHz
IP 20
RED, RoHS, WEEE
Radio: Class III
5 VDC
Repeater
088U1102
VIMCG30F | 088N3678