Installation Guide
Configuration
2a: Configure outputs
1 . Select "Set up Relays" .
2b: Configure inputs
1 . Select "Setup Inputs" .
3: Add an output to a room
Configuration Danfoss Link™ HC to a system is made from the Danfoss Link™ CC Central Controller .
For further information, see the Danfoss Link™ CC instruction manual: Configuration 7: Adding service
devices.
1 . Select "Room devices" .
Danfoss Link™ HC
2 . Select "Boiler Relay" or "Pump
Relay" .
2 . Select input to configure .
2 . Select "Add a device" .
VIFZL15X
© Danfoss
3 . Choose your settings and press
"OK/Return" .
3 . Choose your settings and press
"OK/Return" .
3 . If Danfoss Link™ HC is installed,
a selection screen appears .
08/2010
GB
9