2A: Configure Outputs; 2B: Configure Inputs; 3: Add An Output To A Room - Danfoss Link HC Produkthandbuch

Installation Guide
Configuration
2a: Configure outputs
1. Select "Set up Relays".
2b: Configure inputs
1. Select "Setup Inputs".

3: Add an output to a room

Configuration Danfoss Link™ HC to a system is made from the Danfoss Link™ CC Central Controller.
For further information, see the Danfoss Link™ CC instruction manual: Configuration 7: Adding service
devices.
1. Select "Room devices".
Danfoss Link™ HC
2. Select "Boiler Relay" or "Pump
Relay".
2. Select input to configure.
2. Select "Add a device".
VIFZL35X © Danfoss 04/2011
3. Choose your settings and press
"OK/Return".
3. Choose your settings and press
"OK/Return".
3. If Danfoss Link™ HC is installed,
a selection screen appears.
GB
9