Warnings; User's Responsibility For Ce Compliance - Ramsey Winch H-89 Bedienungsanleitung

R a te d L in e P u ll
L a ye r o f R o p e
*R a ted li n e p u ll p e r
la ye r
*R o p e C a p ac ity
P e r L a y er
*L in e s p ee d a t
1 14 L P M (3 0 G P M )
* T h e s e s pe c ific at io n s a re ba s e d on re c o m m e nd e d 16 m m (.6 3 in ) 1 9 60 gra de
w ire ro p e a n d a 2 44 c c (14 .9 c u in )/R e v. m o to r.

Warnings

• The user shall ensure that the operating personnel are given the necessary
training.
• The operator shall always work in compliance with the operating
instructions.
• Clutch must be fully engaged before starting the winch operation.
• Do not disengage clutch under load.
• Stay out from under and away from raised loads.
• Stand clear of rope while pulling. Do not try to guide rope.
• It is forbidden to move loads above the rated capacity of the winch.
• Do not try to move fixed or obstructed loads.
• Do not use winch to lift, support, or otherwise transport people.
• A minimum of 2 wraps of rope around the drum barrel is necessary to
hold load.
• Avoid conditions where load shifts or jerks occur. Excessive "inching" shall
be avoided.

USER'S RESPONSIBILITY FOR CE COMPLIANCE

1. Use only a motor spool (open center) control valve per Hydraulic System
Requirements.
2. If a remote-operated winch control valve is used, refer to Hydraulic System
Requirements for Emergency Stop components to be installed.
3. Adjust system relief pressure per Hydraulic System Requirements.
4. Install the required hydraulic motor and "A" port motor control valve as shown in
the Hydraulic System Requirements.
5. Mount winch per Winch Mounting Instructions.
6. Install 16 mm (.630 inch), grade 1960 wire rope. Maximum rope length of 38 m
(125 ft) for three layers maximum. Attach rope to the drum per Rope Installation
Instructions. Hook must have a safety latch and a minimum breaking strength
of 225 kN.
N o is e L e v el : 8 0 d B (A ) a t N o L o ad
89 ,0 k N
2 0, 0 00 (lb )
G e ar R e d u c tio n
1
k N 8 9 ,0
(lb ) 20 ,0 0 0
m * 1 0
(f t)* 3 5
M PM 5, 4
(F P M ) 1 8
4
4 0: 1
2 3
73 ,8 6 3, 2
1 6, 60 0 1 4 ,2 00
23 3 8
75 12 5
6 ,3 7 ,2
21 2 4