Specifications; Warnings; User's Responsibility For Ce Compliance - Ramsey Winch HD-P 177,9 Bedienungsanleitung

SPECIFICATIONS*

Rated Line Pull (lbs.)
Noise Level
Ambient Tempereature Range
Gear Reduction
Weight (without rope)
LAYER OF ROPE
*Rated line pull
per layer
*Rope capacity
per Layer
*Line speed
at 64,3 LPM
(at 17 GPM)
* These specifications are based on recommended 20mm (.787") Bridon Dyform
34LR/PI/MAX 1960 grade wire rope or equivilant with minimum breaking strength
of 355,8 kN (80,000 lb) and a 195 cc (11.9 cu in /rev)

WARNINGS:

THE USER SHALL ENSURE THAT THE OPERATING PERSONNEL ARE GIVEN THE NECESSARY TRAINING.
THE OPERATOR SHALL ALWAYS WORK IN COMPLIANCE WITH THE OPERATING INSTRUCTIONS.
A MOTOR SPOOL (OPEN CENTER) DIRECTIONAL CONTROL VALVE IS REQUIRED FOR BRAKE OPERATION.
CLUTCH MUST BE TOTALLY ENGAGED BEFORE STARTING THE WINCHING.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 2 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
AVOID CONDITIONS WHERE LOAD SHIFTS OR JERKS OCCUR. EXCESSIVE "INCHING" SHALL BE AVOIDED.
USER'S RESPOSIBILITY FOR CE COMPLIANCE
1. Use only a motor spool (open center) control valve per Hydraulic System Requirements.
2. If a remote-operated winch control valve is used, refer to Hydraulic System Requirements for Emergency Stop
components to be installed.
3. Adjust system relief pressure per Hydraulic System Requirements.
4. Mount winch per Winch Mounting Instructions.
5. Install 20mm (.787 inch), grade 1960 wire rope with minimum breaking strength of 355,8kN (80,000 lb). Maxi-
mum rope length of 65 m (215 ft) for five layers maximum. Attach rope per Rope Installation Instructions. Hook
must have a safety latch and a minimum breaking strength of 445 kN.
1 2
kN
149,5
177,9
Lbs.
33,600
40,000
M. 9 19
Ft. 30 65
4,2 5,0
MPM
16.3
13.8
FPM
1
177,9 kN (40,000 lb)
-28C to 60C (-20F to 140F)
51.35:1
365 kg (804 lb)
3 4
113,0 100,1
128,5
25,400 22,700
28,900
48
33
160
110
6,5
5,7
21.3
18.8
76db
5
65
215
7,3
23.8