User's Responsibility For Ce Compliance; Specifications; Warnings - Ramsey Winch RPH 42,2 Originalanleitung

SPECIFICATIONS*

First Layer Line Pull
Noise Level
Ambient Temp. Range
Gear Reduction
Weight (without rope)
LAYER OF ROPE
Line pull per layer
* Rope Capacity Per Layer
m
STD. DRUM
ft
m
"Y" DRUM
ft
* Line Speed at
MPM
56,7 LPM
FPM
(15 GPM)
* These specifications are based on recommended wire rope of 11 mm (.433") 1960
grade wire rope and a 408 cc (24.9 cu in) /Rev. motor.

WARNINGS:

THE USER SHALL ENSURE THAT THE OPERATING PERSONNEL ARE GIVEN THE NECESSARY TRAINING.
THE OPERATOR SHALL ALWAYS WORK IN COMPLIANCE WITH THE OPERATING INSTRUCTIONS.
A MOTOR SPOOL (OPEN CENTER) DIRECTIONAL CONTROL VALVE IS REQUIRED FOR BRAKE OPERATION.
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF ROPE WHILE PULLING. DO NOT TRY TO GUIDE ROPE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PERSONNEL.
A MINIMUM OF 2 WRAPS OF ROPE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
IN CAR CARRIER APPLICATIONS, AFTER PULLING VEHICLE ON CARRIER, BE SURE TO SECURE VEHICLE TO CARRIER
BED. DO NOT MAINTAIN LOAD ON WINCH ROPE WHILE TRANSPORTING VEHICLE. DO NOT USE WINCH AS A TIEDOWN.
AVOID CONDITIONS WHERE LOAD SHIFTS OR JERKS OCCUR. EXCESSIVE "INCHING" SHALL BE AVOIDED.

USER'S RESPONSIBILITY FOR CE COMPLIANCE

1. Use only a motor spool (open center) control valve Per Hydraulic System Requirements.
2. If a remote-operated winch control valve is used, refer to Hydraulic System Requirements for Emergency Stop
components to be installed.
3. Adjust system relief pressure per Hydraulic System Requirements
4. Mount winch per Winch Mounting Instructions.
5. Install 11 mm (.433 inch), grade 1960 wire rope. For STD drum, maximum rope length of 36 M (120 ft) for four
layers maximum. For Y drum, maximum rope length of 24 M (80 ft) for four layers maximum.
Attach rope to the drum per Rope Installation Instructions. Hook must have a safety latch and a minimum breaking
strength of 106 kN.
STD. DRUM
"Y" DRUM
1 2
kN 42,2 35,2
lb 9,480 7,900
6 15
20 50
4 9
15 30
9,7 11,2
32 37
42,2 kN (9480 lb)
75 db
-28C to 60C (-20F to 140F)
5.1:1
49,9 Kg (110 lb)
47,6 Kg (105 lb)
3 4
30,2 26,4
6,700 5,900
24 36
80 120
16 24
55 80
13,0 14,8
43 49
4